Tuesday, August 29, 2017

iPhone 6 Screen issue: the screen is blurry after drop into water



What makes you dizzy?  The spoken screen! The screen of iPhone 6 is blurry, because it drop in to water before. It won't boot before, and when fix the motherboard, it can boot, and the we found the screen is blurry. For our eyes and nice intentions, we need to fix it.



Firstly, test it with new screen, it displays normally, so we exclude the problems from motherboard. Problems happen at screen or flex cable.

According the repair experience, when the iron sheet at the upper board is solidifying the screw, the middle screw hole is twisted through. Thus the PCB is damaged and the screen is blurred. Only one circuit is under the screw, which is the 1.8V power supply of screen. The power is not sent to screen normally. I presume that this iPhone has the same reason. Observing under VGA digital microscope, I do not find such a problem but find that the pin of 1.8V power supply is eroded and turns black, as shown in picture 6-71 and 72.



Then, use ultrathin blade to scratch the solder pad and socket pins slightly. Mount some tin and it shines, as shown in picture 6-73.


Finally, we assemble the iPhone and test it, the screen displays normally, the iPhone 6 can back to normal.

Note:

As those water-damaged iPhones, after they are fixed, if the peripherals cannot be used, first we have to check whether each pin is eroded or not, especially the power supply pins.

No comments:

Post a Comment

2021 IBOX2 PCIE NAND DFU Purple Screen Programmer For iPhone/iPad Repair

This is an article about the introduction of ibox2 programmer features, the main functions of the ibox2 programmer are PCIE Nand flash prog...