As we know, the most easily damaged part of the iPhone 6 Plus is the touch. The iPhone 6 Plus touch failure includes iPhone touch screen uncontrol, screen hopping randomly, zebra flicker on the top
of the screen and so on. Now, we troubleshoot it step by step.
First of all, replace a new screen to test, if the issues still exist, then we can start to detect the iPhone motherboard.
Test the
ground resistance of the touch pin, which can intuitively let us find out where
the problem is. At the same time, we can see that the 18
pin is the synchronous signal of CPU through the black touch M1 pin. If all
these resistances are normal, voltage test should be started. By voltage test,
we can more accurately judge which chip is damaged.
The voltage test must be buckled to the
screen for voltage output, three power supply for black touch: +-5.7V shows
power supply, and 1.8V shows it is given by power IC . As shown in picture 11-12-2.
Two power supply of white touch : 5.1V
display power supply, 1.8V power supply IC. As shown in picture 11-12-3.
It is possible to judge which IC is damaged according to the results measured.
The water damaged device shows that the
power is easy to burn out so that 5.1V and white touch +-5.7V cannot be given.
Broken device fault mostly shows on black touch, false welding is the most
possible problem. During the soldering process, some technicians do not remove
and redo but directly heat to the chip, customers can use them normally, but
they will come back to repair after a while. It is better to take the chips off
and replace the new ones.
The point of the black touch M1 pin is at
the top of the plate layer, and it is easy to break the wire to cause the iPhone 6 Plus CPU signal to not be delivered,
so we need to use the jumper wire to solve this problem. There is a point below
the R2410, and the M1 pin is a circuit line, gently scraped with a blade under
a magnifying glass, then get a little solder on the blade,
blowing a small solder ball out with ESD hot air gun, it must be small, then welding the solder ball at that
point scraped out with slow speed air gun, using a copper wire (can take off
from solder wick) to fix on the scrape point and M1 pin, add the green oil and
put under curing UV light. The process looks more complex, but the effect is
very good, and it is basically no rework necessary.
In addition, take care not to damage the
small components around the points, here are 2490, FL2486, C2439 three
components,which are used for identifying the original screen, after you change
the iPhone touch IC and install the
original screen, if the screen is still not responsive but assembly screen can
work, that is the problem.
After installing the black touch IC, check whether
the resistance of C1577 is normal, because it goes into IC, and it is
surrounded by grounding pins. If the current is directly loaded onto 500mA on Fluke 15B+ Digital Multimeter,
most of them are caused from here.
In the end, just be careful and be patient during the repair process!
No comments:
Post a Comment